What are the requirements for the working environment of a five axis machining center factory

The five axis machining center factory has the following requirements for the working environment:

1、 Environmental requirements for the location of machining centers in a five axis machining center factory
The location of the machining center should be away from the vibration source, avoid direct sunlight and thermal radiation, and avoid the influence of humidity and airflow. If there is a vibration source near the CNC machine tool, anti vibration grooves should be set up around the machining center. Otherwise, it will directly affect the machining accuracy and stability of the five axis machining center, resulting in poor contact of electronic components, failure, and affecting the reliability of the machining center.

2、 Power requirements
Generally, machining centers are installed in machining workshops, which not only have significant changes in environmental temperature and poor usage conditions, but also have a variety of mechanical and electrical equipment, resulting in significant fluctuations in the power grid. Therefore, the installation of the machining center requires strict control of the power supply voltage. The fluctuation of power supply voltage must be within the allowable range and remain relatively stable. Otherwise, it will affect the normal operation of the CNC system of the machining center.

3、 Temperature conditions
The ambient temperature of the five axis machining center is below 30 degrees Celsius, and the relative temperature is less than 80%. Generally speaking, the CNC control box is equipped with an exhaust fan or a cooling fan inside to maintain the working temperature of electronic components, especially the central processing unit, constant or with minimal temperature difference changes. Excessive temperature and humidity will lead to a decrease in the lifespan of control system components and an increase in malfunctions. The increase in temperature and humidity, as well as the increase in dust, can cause bonding on integrated circuit boards and lead to short circuits.

4、 Use the machining center according to the instructions
Users are not allowed to arbitrarily change the parameters set by the manufacturer in the control system when using the machining center. The setting of these machining center parameters is directly related to the dynamic characteristics of each component of the machining center. Only the gap compensation parameter values can be adjusted according to the actual situation. The above is our summary and sharing based on years of experience. For more knowledge about five axis machining centers, please follow our website.